How to edit the "message to insert disk #"

by **Mac** on Wed Oct 29, 2003 1:10 pm

In the dvd preview module, if I select "play" for an offline dvd; the message to insert disk #x is shown. How can I edit that message and increase the time it is shown?

thanks,

by **wumagic** on Fri Oct 31, 2003 7:56 am

how do you get that message? When I click to play one of my offline dvd's it doesnt prompt me for the disk... I can play my online DVD's fine though....

by **Mac** on Fri Oct 31, 2003 12:32 pm

I'm using version 38. In the dvdviewer module, if it is a movie that I have not saved on my hard drive, I get the message when I select the play button.

by **stevenhanna6** on Fri Oct 31, 2003 4:40 pm

that message was removed from alpha39....I guess I should add it back....there is no way of editing it in alpha38.

by **s.morris** on Wed Jul 14, 2004 7:18 am

Hi Steve

that message was removed from alpha39....I guess I should add it back....there is no way of editing it in alpha38.

was this put back in, 1 minute i was getting the message now iam not, just installed the lates exe

the offline box is ticked and video_ts.ifo is in the parameters

any ideas any one :?:

thanks

Steve

by **stevenhanna6** on Thu Jul 15, 2004 4:46 am

morris, this is done with the showoverlay command now....basicly you make a screen that shows whatever offline info you want...show it as an overlay and add it to the filetypes section so it knows to launch that event when its an offline movie. I would say just hold off if you cant figure it out because the next release will be comming out this week if everything goes according to plan...and off course it will be preset to do this.